Coefplot after SEM, standardized

[Matthew Bergman]

I am attempting to use coefplot to graph standardized effects. I used the "estat teffects, standardized" command. I am able to read the output of all three, but cannot figure out how to get a coefficient plot.

The command as suggested by the stata manual: ftp://ftp.repec.org/opt/ReDIF/RePEc/...3-coefplot.pdf
is "coefplot, b(b_std) v(V_std) drop(_cons) xline(0) xtitle(Standardized Coefficients)"

I get a plot, but I am unsure if these are direct effects, indirects, or total effects (I am running a non-recursive model). I am also running two paths, so I am unsure how to get the plot for the second path.

In short, the command works and I get a plot, but theoretically, I have 6 sets of coefficients I should be able to recall and plot.

[Matthew Bergman]

Typo; it is a recursive model; if it helps, the form is similar to. This is why I have both direct and indirect effects for variables a, b, and c

a b c --> d
a b c d --> e